The adhesive mixture WALLMIX B-3 is intended for building of internal and external walls by blocks from heat-insulating cellular concretes, such as aerated concrete, foam concrete, gas silicate, etc.
A mixture of cement with mineral aggregates and modifying additives.
Preparation of the surface.
Carried out in accordance with the requirements of DSTU-N B A.3.1-23: 2013, DBN B.2.6-33: 2008 and DSTU-N B B.2.6-212: 2016. The blocks must be dry, strong and cleaned from dust, dirt, oil, grease, wax and paint residues.
Pour the dry mixture into a container with clean water at room temperature in the proportion of 0.18-0.21 l per 1 kg of mixture (4.5-5.25 l per 25 kg bag). Thoroughly mix with a stirrer or low-speed drill with a nozzle to a uniform consistency without lumps and clots. Then soak the solution for 5 minutes and mix thoroughly again. The solution retains its adhesive properties for 2 hours.
Caution! Do not add other components to the mixture.
When performing works it is necessary to comply with the requirements of current regulations. The adhesive mixture is applied to a dust-free surface using adhesive carriages, buckets or notched trowels. The size of the teeth of the spatula (from 4 to 12 mm) is chosen according to the desired thickness of the layer of adhesive solution. The blocks are installed on the distributed mortar mixture, pressed and adjusted in position with a rubber mallet.
The work should be performed at a temperature of +5°C to +30°C. The most effective result is achieved at a temperature of +20 ° C and a relative humidity of 60%. In other conditions, the operating parameters of the mixture may change. When performing works, the facade must be protected from direct sunlight, as well as high humidity (rain, fog, etc.).
Consumption. The consumption of the mixture is 5-6 kg / m2 with a seam thickness of 3 mm. Per 1 m3 of masonry – about 23 kg.
Safety rules. The mixture contains cement, which causes an alkaline reaction at the time of hydration, so when working it is necessary to protect the eyes and skin. In case of contact with eye solution, rinse immediately with running water and seek medical advice.
The mixture must be stored in branded airtight packaging in a dry place, on pallets. Shelf life 12 months from the date of manufacture indicated on the package. Use damaged bags first.
Packaging. Paper bags with an inner plastic layer of 25 kg.
Warning! The manufacturer is not responsible for improper use of the material, as well as its use for other purposes and conditions not provided for in the technical description.
The proportion of the mixture 0,18-0,21 L water/kg
Consumption of the mixture per 1 mm of solid layer ~ 1,5 kg/m2
Shelf life of the solution for use 2 hours
Compressive strength min 5 MPa
Adhesion strength to the base min 0,2 MPa
Frost resistance min 50 cycles
Base temperature from +5°C to +30°С
Operating temperature from -30°C то +70°С
In connection with the constant optimization of the mixtures, please refer to the technical description on the manufacturer’s website. From the moment the latest version of the technical description, all previous ones become invalid.
STORE IN A DRY PLACE!
MIXTURE by TM “WALLMIX” Ts.1.ZK1 DSTU B V.2.7-126: 2011.
Production address: st. Magnitogorskaya, 1, Kiev, 02094, Ukraine.