Adhesive primer WALLMIX Quartz acrylic primer is designed for pre-treatment of substrates in order to increase adhesion, strengthen the substrate and facilitate the application of decorative plasters. Suitable for preservation of facades of the insulation system for the winter.
Water dispersion of synthetic resins with mineral fillers, pigments and modifying additives.
Carried out in accordance with the requirements of DSTU-N B A.3.1-23: 2013 and DSTU- N B B.2.6-212: 2016. The base must be solid, cleaned from dust lime, grease, oil or emulsion paints. During repair work, before applying the paint, fragile areas of substrate must be thoroughly cleaned to a solid layer or must be removed. Dense mineral bases, such as a bricklaying, concrete bases, cement-sand and cement-lime plasters, gypsum plasters and gypsum cardboard sheets, wooden surfaces need to be processed by a primer universal WALLMIX Universal and to maintain from 4 to 6 hours. Mix the contents of the can with the drill at low speed. Apply the primer with a brush or paintbrush. Work on one surface should be performed continuously, following the rule of «wet on wet». Depending on the ambient temperature and humidity, the drying time if from 4 to 6 hours.
The work should be performed at a temperature of +5°C to +30°C. The most effective result is achieved at a temperature of + 20° C and a relative humidity of 60%. Under other conditions, the operating parameters of the mixture may change. At the beginning of the work, for at least 24 hours, the solution must be protected from direst sunlight, as well as high humidity (rain, fog, etc.)
The consumption of a primer is ~0,35 – 0,7 L / m2, depending on the surface and skills of the executor.
In case of contact with eyes, flush immediately with running water and consult a doctor.
The primer must be stored in original sealed packaging in a dry place, at temperature from +5ºС to +35 ºС. The shelf life is 12 months from the date of production indicated on the package.
Plastic buckets of 1L, 5L and 10L.
|Film colour after drying||Milky white|
|Density of emulsion||1,5 KG/L|
|Drying time||from 4 to 6 hours|
|Emulsion consumption||~ 0,35-0,7 kg/m2|
|Substrate temperature during application||From +5 °C to +35 °С|
|Operating temperature||from -30 °C to +70 °С|